Edge Finder Ceramic Non-Magnetic WH-1010 10mm Dia x 86mm Long 5632500 Cutter diameter 13

Cutter diameter 13

S-Carb 3-Flute End Mills with Corner Radius for

The cone makes pulling back from the bore easier

prevents seizing and galling of surfaces

Edge Finder Ceramic Non-Magnetic WH-1010 10mm Dia x 86mm Long 5632500 Cutter diameter 13Mechanical Hardened ground and lapped to close tolerances, the edge finder is placed in a chuck and the work table is then traversed to make contact between the rotating edge finder and the work. Contact will shift to a concentric position relative to the body and with very slight additional movement this will move off centre with a decided wobble. At this point the centre of the finder is exactly one half the diameter of the contact from the work