5 Degree Taper Chair Making Router Bit 1/2" Shank DC01 reduces waste

reduces waste

and 2mm and 8mm No

Permanently lubricated bearings and Acme screws on the inside and a precision-ground cast iron table with cast aluminum alloy upper and lower trunnions mean this saw is built to last from the inside out

Developed to keep workspaces neat and clean

5 Degree Taper Chair Making Router Bit 1/2" Shank DC01 reduces wasteMaster craftsman and woodworker Sam Maloof perfected his joinery to a level of artistry that many aspire to achieve. Sam developed a very specific set of bits that aided him in joining the seat pan to the front and rear legs. These bits include a positive 5 degree taper (#151098), and negative 5 degree taper (#151099). These allow you to make the specific dovetail joint needed to create your Maloof Inspired creations. Maloof Inspired chairs also need