Tork Craft | Annular Hole Cutter HSS 46 X 30mm Broach Slugger Bit Type_Pipe Clamps For working in tighter spots

For working in tighter spots that the 6” driver can’t reach

The materials utilized to manufacture Dasqua 1380-3010 Mono Block Vernier Caliper 0-200 mm

Wear-resistant design for a long service life

The machine has a 10mm chuck shank and a single-sleeve chuck for easy screw bit and drill changes

Tork Craft | Annular Hole Cutter HSS 46 X 30mm Broach Slugger Bit Type_Pipe Clamps For working in tighter spotsAnnular Hole Cutter HSS 46 X 30mm Broach Slugger Bit One way to avoid dimpling and deburring while making holes in tube and pipe is to use annular cutters. Because annular cutters are hollow on the inside, there is no dead zone resistance to overcome. Using a twist drill to make holes in pipe or tubing can prompt concerns about the hole roundness, location accuracy, hole finish, chip extraction, burrs, and drilling duration. The focal point of these